Here is how to recalibrate a hayward aqua rite turbo cell in three simple steps.
Aqua rite t cell 15 reset.
T 15 is the factory default.
As a precaution the cell can be installed vertically or in an inverted manner from the manufacturer.
This is a 15000 gallon pool.
Aqua rite salt chlorinator has a built in reminder to inspect and clean the cell every 500 hrs.
The average salt level needs to be reset for start up and when a cell is replaced.
How to reset inspect cell light.
Low flow conditions can result in insufficient water in the cell causing inefficient chlorine production.
T 1 5 is the factory default.
Spoke to hayward and i ended up replacing the t cell 15.
If the incorrect cell is chosen the salt level amperage and voltage will not be correct and the system will turn the chlorinator off.
Replacement turbo salt cell for the goldline aqua rite salt chlorinator from hayward hayward replacement part number t cell 15.
The first thing to do is to remove the cell and check the blades inside for buildup.
6 40 t cell 9.
While both the t cell 15 and the t cell 15ll can support pools up to 40 000 gallons in size the regular t cell 15 is designed to produce around 580lbs of chlorine throughout its life before it needs to be replaced.
We often get calls from people having a problem where their hayward aqua rite salt chlorinator system is reading a different salt level than manual testing.
Its showing salt level of 2700.
Slide the main switch to the auto position.
The cell size displayed here has to match the installed cell to ensure proper operation including salt calculation.
Often times pool owners can solve this by recalibrating the salt cell.
I just added a 40 lb bag of salt.
The cell install in this system is t 3.
How to set turbo cell type to switch cell type cycle main switch from auto super chlorinate auto.
Water tests at 3500 ppm salt.
I thought of cleaning the cell because it says on the cell theres a sticker inspect and clean every 3 months.
Ran through the calibration and all seemed right at 3400.
Factory default is 2800ppm.
Waiting to see if that helps.
How to set turbo cell type before operation the aqua rite must be configured for the chlorinator cell that will be used.
The check salt and inspect cell lights are flashing.
Came back and looked at the aqua rite the next morning and it reads 2200.
Page 4 before operation the aqua rite must be configured for the chlorinator cell that will be used.
How to set turbo cell type before operation the aqua rite must be configured for the chlorinator cell that will be used.
Push 8 cell size the aqua rite scg uses one of 4 cell sizes t 15 t 9 t 5 or t 3.
First check the display salt reading if it s 2 700 ppm or lower the check salt light will come on.
It is designed to deliver everything the original t cell 15 already does but with an additional 25 lifespan.
I havent removed the cell yet.
