Apply Vinyl Lettering Windex

There are many youtube videos and websites that have great tutorials on how to apply vinyl die cut decals.

Apply vinyl lettering windex.

Whether you are applying a small decal such as a college sticker or parking permit or adhering a large rear window graphic choosing the right tools in the best weather conditions and taking plenty of time will assure effective decal application. Apply vinyl lettering to your surface lower the mask layer and using your squeegee press firmly at a 45 degree angle starting from the middle and going out. If air bubbles occur puncture with a pin and smooth down. Surface should be clean and dry before applying vinyl lettering.

Remove the wax paper. Final note the application of this vinyl decal requires a degree of dexterity and concentration. Glass cleaners such as windex can be used to remove dirt grit and water soluble substances. Such as metal glass plastic wood wall board etc.

Peel the backing paper from the decal. Vinyl can be applied to any smooth surface. This is key and it s a good time to walk away from the car. They are all a little different but very helpful.

Wipe away the excess windex and let the decals take a set. How to apply vinyl lettering racing stripes vinyl stickers vinyl decals pinstripes and more. To apply a vinyl cut decal prepare the metal as above and wash with soap and water including new paint. Squeegee windex from under the decal beginning in the center and working outward.

Apply rubbing alcohol to remove any remaining oils or waxes from the vehicle s surface. Get the best results when applying car window decals by following expert tips. Use the squeegee to squeeze out all the windex and air bubbles from underneath the decal. Apply water to the back side of the.

The vinyl will not stick as well to any oil or waxy surface. If there are larger areas with the adhesive we recommend spraying the area with windex and with a soft cloth that will not scratch the vinyl clean the area. Only remove the wax paper when you are ready to apply the decal to prevent dirt from getting on the adhesive surface. The ammonia interferes with the adhesive.

Peel off the wax paper using a friend to help with bigger decals. With some elbow grease the adhesive can be removed. Spray the adhesive side of the decal with windex after or as you peel away the backing paper. If you have never applied vinyl die cut decals it is recommend to do a little research online.

The adhesive on the back of the vinyl lettering should stick well to your surface if it has been properly cleaned and prepped. Do not use windex in an aerosol can.